Software Upgrades and Help Files

Polarographic Probe Notes for ASET v2.00

These notes are for applications using a 1mV/nA headstage from Applicable Electronics, Inc. It is assumed that:

• A/D Channel 4 is being used to read the highest gain signal out of the main amplifier
  
• A/D Channel 5 is being used to read the lower gain signal out of preamp for setting the D/A channel
  
• D/A Channel 0 is being used to provide a bath offset level for the difference amplifier
  
• D/A Channel 1 is being used to provide the polarization voltage
  

When the main amp is set to 10, here are the correct settings for the Calibration dialog box and point sampling rules:

 

When the main amp is set to 100, here are the correct settings for the Calibration dialog box and point sampling rules:

 

The main Sampling Rules dialog will look similar in both cases, the important settings are in the Update Bath section:

Maintained by Anastasia Karplus
email: sia@sciencewares.com
last updated 2/4/2005
Copyright © 2005 Science Wares, Inc., all rights reserved.